Ripping Off Change Machines
This is for the type of change machine that
changes $1 or $5 bills to coins.
1) Find the type of change machine that you slide in your bill length wise, not the type
where you put the bill in a tray and then slide the tray in!!!
2) After finding the right machine, get a $1 or $5 bill. Start crumpling up into a ball.
Then smooth out the bill, now it should have a very wrinkly surface.
3) Now the hard part. You must tear a notch in the bill on the left side about 1/2 inch
below the little 1 dollar symbol (See Figure).
4) If you have done all of this right then take the bill and go out the machine. Put the
bill in the machine and wait. What should happen is: when you put your bill in the machine
it thinks everything is fine. When it gets to the part of the bill with the notch cut out,
the machine will reject the bill and (if you have done it right) give you the change at
the same time!!! So, you end up getting your bill back, plus the change!! It might take a
little practice, but once you get the hang of it, you can get a lot of money!
!--------------------------------!
!
!
! (1) /-------\
(1) !
! !
!
!
! ! Pic.
! !
! (1) /\ \-------/ (1) !
! ! !
!
!-----/ \-----------------------!
\-------Make notch here. About 1/2 " down from